|
Who's Online
There currently are 5808 guests and 3 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
FAX-L1000 Chapter 5: Appendix
Cold Reset may be any of the following three types: �Cold Reset Used to rest all settings except the recording paper size under PAGE COUNT and TEST PRINT of TEST MENU back to their factory default settings. �Cold Reset A4 Used to set the recording paper size under TEST PRINT to A4 and to reset all other settings to factory default settings. The PAGE COUNT data will be cleared. �Cold Reset LTR Used to set the recording paper size under TEST PRINT to LTR and to reset all other settings to factory default settings. The PAGE COUNT data will be cleared. If you have installed a PDL board, be sure to use Cold Reset A4 or Cold Reset LTR. If you want A4 for TEST PRINT of TEST MENU, use Cold Reset A4; on the other hand, if you want LTR, use Cold Reset LTR. If you have installed a different module or card, use Cold Reset. �Cold Reset LTR (1) Make sure that the main unit is unplugged. (2) Press and hold down the Item, Value and Enter/Cancel buttons at the same time. Then plug the main unit in while still pressing the Item, Value and Enter/Cancel buttons. (3) When you see the �COLD RESET LTR� message, release all the buttons. �Cold Reset A4 (1) Make sure that the main unit is unplugged. (2) Press and hold down the Menu, Item and Value buttons at the same time. Then plug the main unit in while still pressing the Menu, Item and Value buttons. (3) When you see the �COLD RESET A4� message, release all the buttons. �Cold Reset (1) Make sure that the main unit is unplugged. (2) Press and hold down the Go button. Then plug the main unit in while still pressing the Go button. (3) When you see the �COLD RESET� message, release all the buttons. � After the factory defaults have been reset, the main unit enters the standby mode. � The main unit automatically checks which options are installed after a cold reset is performed. When the main unit has finished warming up, the On Line indicator comes on and �READY� appears in the display.
NOTE
5-222
|
|
|
> |
|