|
Who's Online
There currently are 5742 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
tres bon document
cela a permis de verifier la connection de l'ecran
merci
salutations
;
The manual was of good quality with high resolution schematic diagrams.
;
The manual was very clear and contained all the information I was looking for. My dishwasher is working again because of this servicemanual!
;
Quality scan, great manual. I solved my problem with this manual.
;
The AKAI 1720 model reel to reel tape recorder described in this Manual is quite an old unit - circa late 1960's. As a consequence, the description of the mechanical details - and adjustments thereof - is quite critical. The manual does this quite well. The schematics are also well presented and have detailed PCB overlays. Probably the only negative is that some half-tone detail has been lost from the original manual as it has been scanned in simple B&W.
d. Fitting the Grid Wire for the Primary Corona Unit 1 ) Loosen the three screws holding the block (front) in place, move the block (front) into the direction of the arrow shown in Figure 4-509, and tighten it temporarily.
Free a length of wire from the reel of the corona wire (O.lmm dia.), and form a loop with a diameter of 2 mm at its end. 3) Cut the end of the twisted corona wire [excess) to less than 1 mm with a nippier. 4) Hook the loop on the stud shown in Figure 4-5 10, and fit it in the order shown in the figure. 5) After (Figure 4-5 lo), wind the end of the corona wire around the fixing screw to fix it in place. 6) Cut the excess wire to less than 1 mm with a nipper. 7) Loosen the screw tightened temporarily in step 1) once again, and move the block into the opposite direction of the arrow shown in Figure 4-509, and adjust the tension of the grid wire. 9) Wipe the grid wire with a dry cloth. 9) Check the tcllowrng: . The grid wire is free of bends or twists and its gold plating has not peeled. . The wire is fitted at equal intervals, i.e., the grid wire is inside the groove of the bloc-k.
2)
@ Mounting
screws Figure 4-509
Note: To form the loop, wind the corona wire around the hex key once, and turn the hex key three to four times; thereafter, twist the corona wire.
Figure
4-510
COPYAlCHT
0
1991CANONINC.
CANONNP.483514835114835S14335 AN 0 WT
1988PRlNTE9 JAPANlIMPRIME JAPONI IN AU
4 - 28
$4.99 NP4335 CANON Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
|
> |
|